Turning The System Components On And Off - Sennheiser EMP 2015 Instruction Manual

48

Turning the system components on and off

Turning the amplifier on/off
The amplifier is fitted with both a mains switch
. Via the mains switch, the amplifier can be disconnected from the mains
(position "0"). The mains switch can always remain set to "I".
When putting the system into operation, turn the amplifer on by setting
the mains switch
During normal operation, turn the amplifier on or off by using the operating
switch .
To disconnect the amplifier from the mains, set the mains switch to "0".
Turning the receiver section on/off
The receiver section is fitted with a separate ON / OFF switch
always remain set to "ON".
Adjusting the volume of the microphone
Set the MICROPHONE volume control
amplifier on. Adjust the volume of the microphone after turn-on.
Adjusting the volume of connected audio devices
Set the LINE IN volume control
Adjust the volume of the connected audio devices after turn-on.
Note:
With the two volume controls
signals can be mixed for reproduction at the loudspeaker output.
Turning the transmitter on/off
Slide back the cover plate
Press the ON / OFF button
lights up.
To turn the transmitter off, press and hold the
"OFF" appears on the display. You can then release the button. The red
LED goes off.
Muting the transmitter
Use the MUTE switch
(this switch does not turn off the transmitter).
to "I". The mains switch can then remain set to "I".
to "0" before you turn the
to "0" before you turn the amplifier on.
and , the microphone and LINE IN
.
to turn the transmitter on. The red LED
to noiselessly mute the transmitter's audio signal
and an operating switch
which can
ON / OFF button until