Configuring The Remote Interface; Checking The Meter's Calibration Date; Resetting The Meter's Default Settings - Fluke 8845A User Manual

8845A/8846A
Users Manual
4. To adjust the display to the desired date and time, press either <-- or --> to select
5. Press the ENTER soft key to set the date and time and return to system menu.

Configuring the Remote Interface

Selecting an interface port, setting up the ports, and selecting the command set the Meter
will recognize is accomplished through the Instrument Setup key. For information on the
commands that will remotely control the Meter, refer to the Programmers Manual.

Checking the Meter's Calibration Date

To read the Meter's calibration date:
1. Press I
2. Press the CAL soft key as shown below.
3. Press the CAL DATE soft key to display the date the Meter was last calibrated.
4. Press B to go back to the previous menu.

Resetting the Meter's Default Settings

To reset the Meter's default settings:
1. Press I to see the instrument setup menu.
2. Press the RESET soft key to reset the Meter.
3-22
a specific digit or the month.
With the desired digit or month selected, press the soft key labeled -- to decrement
the digit, or ++ to increment the digit.
+
0.5993
F1 F2 F3 F4 F5
caw034.eps