Troubleshooting
The Test Tool Does Not Start Up
•
The batteries may be completely empty. In this case
the test tool will not start up, even if it is powered by
the battery charger. Charge the batteries first: power
the test tool with the battery charger without turning it
on. Wait about 15 minutes and try turning on the test
tool again.
The Test Tool Shuts Down After A Few Seconds
•
The batteries may be empty. Check the battery
symbol at the top right of the screen. A
indicates that the batteries are empty and must be
charged.
The Screen Remains Black
•
Make sure that the test tool is on.
•
You might have a problem with the screen contrast.
Press
, then press
arrow keys to adjust the contrast.
symbol
. Now you can use the
Maintaining the Test Tool
The Operation Time Of Fully Charged Batteries
Is Too Short
•
The batteries may be in poor condition. Refresh the
batteries to optimize the condition of the batteries
again. It is advised to refresh the batteries about four
times a year.
The Printer Does Not Print
•
Make sure that the interface cable is properly
connected between the test tool and the printer.
•
Make sure that you have selected the correct printer
type. (See Chapter 6.)
•
Make sure that the baud rate matches with the printer.
If not, select another baud rate.
(See Chapter 6.)
•
If you are using the PAC91 (Print Adapter Cable),
make sure that it is turned on.
8
Troubleshooting
93