GBC F-36 Operating And Maintenance Manual page 15

F-36 PRO Laminator Operation Manual
If the laminator is in a crate:
1. Remove the top of the crate and then the sides in
the order shown in Figure 2-4.
Do not allow the top to fall into the crate. It can
damage the laminator.
Do not put packing screws on the floor. They can
cause problems when trying to roll the machine
into position.
A second person must support the side labeled 5
in Figure 2-4. It can fall and damage the
laminator.
NI NG
W AR G
UN
HT E
AC GA RD
E EN
MIS
NI NG
W AR UN G
HT
AC RD E
E EN GA
MIS
Figure 2-4: Removing the Crate
2. Gently unwrap the shrink wrap from around the
laminator.
© GBC Pro-Tech 1999 January
CAUTION
1
W AR
AC NI NG
HT
UN
MIS E EN G
GA
RD
E
800-748 Inc. -0241
System s,
Commu nication
Hazard ©1994
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage to
the rolls.
3. Carefully remove any accessories packed with the
laminator. The accessory pack should contain:
1 Set, hex wrenches
1 Slitting knife
1 Manual
1 Set, spare fuses
1 Tape measure
1 Roll of masking tape
1 Rubber cement eraser
Figure 2-5: The Foot Bolts
4. Remove the screws holding the foot pads onto the
pallet using the Phillips head screwdriver.
5. Have the laminator lifted off the skid and placed on
the floor by licensed riggers. The riggers must also
unscrew the foot bolts from the laminator frame
since it requires lifting the laminator.
Installation
CAUTION
Foot Bolt
Shipping
Pad
2-5