Table of Contents
Advertisement
F-36 PRO Laminator Operation Manual
NOTE
ALL SHIPMENTS ARE EX- WORKS. At our dock, title
passes to the buyer. Please review your insurance cov-
erage prior to shipment, as you are responsible for all
subsequent freight charges and risks. Before signing
the Bill of Lading, be sure to inspect the crate and/or
pallet for signs of damage or missing items; if applica-
ble, make a note of this on the Bill of Lading.
The F-36 PRO Laminator is shipped one of two ways.
It is either encased in a wood crate on a skid or in a
cardboard box on a skid.
The unpacking process requires at least two
people. You can be severely injured or crushed.
Tools required:
•
Phillips head screwdriver
7
•
/
" open end wrench or adjustable wrench
8
If the laminator is in a cardboard box:
1. Remove the securing screws around the bottom of
the box using the Phillips head screwdriver as
shown in Figure 2-2.
© GBC Pro-Tech 1999 January
WARNING
Figure 2-2: Removing the Cardboard Box
2. Lift the cardboard box off the laminator.
3. Gently unwrap the shrink wrap from around the
laminator.
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage to
the rolls.
4. Carefully remove any accessories packed with the
laminator. The accessory pack should contain:
1 Set, hex wrenches
1 Slitting knife
1 Manual
1 Set, spare fuses
1 Tape measure
1 Roll of masking tape
1 Rubber cement eraser
Installation
CAUTION
2-3
Advertisement
Table of Contents
