Setting The Sampling Interval - Fluke 1630 User Manual

1630
Users Manual
If the HI value is set at OL, or the LO value is set at 0, the
ALARM function will be disabled.
The HI value can't be smaller than the LO value and the
LO value can't be larger than the HI value. HI value will be
adjusted to the LO value when a rollover occurs. The
maximum LO value is the HI value.
If data logging is progressing, the beeper is disabled to
save battery power but the display will still show the
warning letters HI-- or LO--.
The values of the high and low alarm are stored in memory.
They are restored when the Clamp is turned on.

Setting the Sampling Interval

1. Press the FUNC button until SEC appears in the upper display. Figure
6 shows the sampling interval display.
2. The Clamp shows the current sampling interval in seconds.
3. Press E or D to increment/decrement the sampling interval by 1
second. The sampling interval can be incremented or decremented
from 0 to 255 seconds. Hold down the up or down buttons to quickly
increment/decrement to the desired value.
F
4. Press
10
until you return to the main display.
Note