Heated Main Rollers; Main On / Off Switch; Table Idler; Swing Around Control - GBC 3064WF Installation And Operating Manual

GBC 3064WF
Figure 10
Figure 11
Figure 12
Figure 13
© 2005 General Binding Corporation
Heated Main Rollers: (Fig. 10 – Item A)
A
Silicone rubber coated steel tubes heat the
laminating film and compresses the heated film
to the items being laminated. Heat is provided
B
by an internal heating element.
Table Idler: (Fig. 10 – Item B)
The Table Idler is used to assist in bringing the
material up to the nip.
The table Idler is helpful in roll to roll operation
and helps move large ridged panels through the
nip.
Main On /
(Fig. 11 – Item A)
Located on the lower back of the control panel
side of the GBC3064WF is the main power
A
switch.
"I" means ON, "O" means OFF.
Swing around control panel arm:
(Fig. 12 – Item A)
A
The Control panel is on a swing around arm
which will allow the operator to move the
necessary control to each side of the machine.
B
Control Panel: (Fig. 12 – Item B)
The Control panel has most of the machine
controls to operate the machine.
Electronic Safety Beam: (Fig. 13 – Item A)
Safety light beam is used to protect the Nip area
with out being, in the way of normal lamination
operation. Please see the following chart for
A
sequence of operations on Page 14.
Operation Manual
Off (I/O) Switch:
Page 12