GBC 80-99 Operating & Maintenance Manual page 34

Operations
Process: Hot overlaminate with Pressure Sensitive Mount Adhesive (Second Pass)
Materials (top/bottom): / 3/16" Foamcore
Front Control Panel
Adjustments
Top Brake
Top Clutch
Laminator Roller
Bottom Brake (front)
Bottom Clutch (front)
Forward/Reverse
Speed
Laminator Roller Shims
Helpful Hints/Notes:
When mounting keep an even wrap around the upper pull roll to eliminate any wrinkles due to
uneven feed of the image. During the mounting process, it is also helpful to have a table the
same height as the pull roller nip to help feed the board and image into the pull rollers.
Page 5 - 20
Orca 80-99 Operation and Maintenance Manual
PROCESS CONTROL CHART 2-6
OFF / NA Top Heat
OFF / NA Bottom Heat
OFF / NA Top Cooling Fans
OFF / NA Bottom Cooling Fans
OFF / NA Pull Roller Clutch
REVERSE Pull Roller Pressure
2 - 3 f.p.m. Bottom Brake (rear)
N/A Bottom Clutch (rear)
Rear Control Panel
Adjustments
Pull Roller Shims
© GBC Films Group June 2000
OFF / NA
OFF / NA
OFF
OFF
ON / 40 p.s.i.
ON / 30 p.s.i.
OFF / NA
OFF / NA
3/16"