Table of Contents
Advertisement
Step 4:
Check the ADSL LED status
Please check the ADSL LED on the front panel. This light indicates the status
of your ADSL broadband through your telephone line. If the light is on, you
can continue setup. However if the light is flashing, there is no broadband
line detected. Please call your Internet Service Provider (ISP) and inform
them about the flashing ADSL light to resolve the issue.
Step 5:
Firewall settings
Please turn off all personal firewalls before you continue the setup – firewalls
can block communication between your PC and router.
Note: You must use the power adapter included in the package with the
router, do NOT attempt to use a third-party power adapter.
Step 6:
PC LAN IP configuration
Configure your PC's LAN settings to automatically obtain an IP address from
the router by following the steps below:
Click "Start" and then select "Control Panel".
1.
5
Advertisement
Table of Contents
