Table of Contents
Advertisement
Inserting/Ejecting a Disc
1
Press
on the unit.
The movable monitor will open.
2
Insert a disc:
Insert a disc into the disc slot. Inserting a disc will close the
monitor automatically.
Disc Slot
Eject the disc:
Press
again.
The movable monitor will open. Then the disc is ejected.
• Do not apply shock to the movable monitor when it is open as it may
result in malfunction of the unit.
• The monitor may be dim during low temperature and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The monitor will stop at the set tilt angle when closing.
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
movable monitor will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
14
-EN
Adjusting the Monitor Viewing Angle
Adjust the monitor's angle for better visibility.
1
Touch [SETUP] for the selected source on the main
screen.
The setup selection screen is displayed.
2
Touch [DISPLAY SETUP].
3
Touch [ ] or [ ] of TILT to adjust the desired
monitor angle.
Pressing the buttons changes the screen angle by 5 stages.
4
Touch [
] to return to the previous screen.
• This function is adjustable while driving.
• If the monitor touches an obstacle while the angle is being adjusted,
it will stop immediately.
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.
• Touching and holding [
] for at least 2 seconds will change to the
main source screen.
Adjusting the Volume
Adjust the volume by pressing
Volume decreases/increases continuously by pressing and
holding
or
.
Volume: 0 - 35
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
or
.
Hide quick links:
Advertisement
Table of Contents
