Figure 219 Menu 11.2.4: Remote Node Filter - ZyXEL Communications ZyWALL 2Plus User Manual

ZyWALL 2 Plus User's Guide
Use menu 11.2.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each
filter field. Note that spaces are accepted in this field. Please refer to
for more information on defining the filters.

Figure 219 Menu 11.2.4: Remote Node Filter

392
Menu 11.2.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Chapter 32 on page 437
Chapter 25 WAN and Dial Backup Setup