Panasonic KX-TG7301E Operating Instructions Manual page 43

TG7301-7321E(e).book Page 43 Thursday, February 14, 2008 9:26 AM
Programmable settings
Problem
I have changed the display
language to a language I
cannot read.
While programming, the
handset starts to ring.
I cannot register a handset to a
base unit.
I cannot remember the PIN.
Battery recharge
Problem
The handset beeps and/or 3
flashes.
I fully charged the batteries, but
3 still flashes.
I fully charged the batteries, but
the operating time seems to be
shorter.
The handset display is blank.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Useful Information
Cause/solution
L Change the display language (page 17).
L A call is being received. Answer the call and
start again after hanging up.
L The maximum number of handsets (6) is
already registered to the base unit. Cancel
unused handset registrations from the base
unit (page 27).
L You entered the wrong PIN. If you forget your
PIN, see "I cannot remember the PIN."
(page 43).
L Place the handset and the base unit away
from other electrical appliances.
L Change the PIN using the following method.
1
K (middle soft key)
2
{V}/{^}: "Base Unit Setup" i M
3
{V}/{^}: "Base Unit PIN" i M
4
{*}{7}{0}{0}{0}
5
Enter the new 4-digit base unit PIN. i
M i {ih}
Cause/solution
L Battery charge is low. Fully charge the
batteries (page 15).
L Clean the charge contacts and charge again
(page 15).
L It is time to replace the batteries (page 14).
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth, and charge
again.
L The handset is not turned on. Turn the power
on (page 17).
43