Removing The Freezer Accessories - Samsung RF24FSEDBSR/AA User Manual

z_ After sliding the foldable shelf inand
CAUTION folding it,the Shelf Front can beremoved
foryour convenience. Ifyou use the self
without removing, becareful ofitspossible
separation.
4. Vegetable & Fruit Drawers
To remove - Pull the drawer out to full extension.
Tilt up the front of the drawer and pull straight out.
To re-install - Insert the drawer into the frame
rails and push back into place.
,4X The drawers need to be removed before
CAUT_ONthe glass shelf above them can be lifted
out.
5. Flex Zone
To remove the Flex Zone - Pull the Flex door
out to full extension. Lift the Flex Zone up, pulling
it to your body with both hands.
To re-instaU the Flex Zone - Open the Flex door
to full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails, and
then lower the front until the whole Zone rests on
the rails.
,/i,i
When the Flex Zone or LED lighting is not
working, check the connectors [ ( 1 ), ( 2 )
shown below ] for cracks or leaks.
26 operat -_g
1. Refer to page 12 for disassembly instructions.
2. Open the cap cover rail with a flat-blade
screwdriver.
Using the doors
Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open, it
will automatically close. If the the door is opened
more than its auto close range, it will remain open.
You must close it manually.
REMOVING THE FREEZER
ACCESSORIES
1. Freezer Room Guard
To remove - Remove the freezer room guard
by lifting the guard up.
To re-install - Push down until the guard ( 1 )
locks into place.
1)
2. Super Extended Drawer
To remove Pull the drawer out to full extension.