Samsung RF24FSEDBSR/AA User Manual page 11

With the
door opened
1. Remove the 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
2. Disconnect the two connectors ( 2 ) on the
left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, you must
CAUTION remove it before removing the tube.
3. Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
(7).
4. Open the door (more than 90 °) , lift from the
middle hinge and remove the door.
Due to its design features, you can
disassemble and re-assemble the Auto
Closing Hinge when the door is open. (The
holes in the Door Shaft and the Door Middle
Hinge are deliberately tilted at specific angles
so that it is difficult to disassemble and re-
assemble with the door closed.)
A Place the door, inside facing up, on a non-
CA-0_TON scratching surface.
Door Middle Hinge Auto Closing Hinge
,,, ,y_<,x ............................ :l
/It
If the Auto Closing Hinge is aligned to be
vertical as shown in the figure, align it to be
parallel by using the Door Middle Hinge. (Refer
to No.5 for the disassembly of the Door Middle
Hinge)
Do not give it too much force while rotating
CA-0TTON it with a flat head screwdriver. It may get
damaged.
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+). Remove the 2 hex head bolts
(9 ) attached to the lower left and right door
hinges with an allen wrench (3/16"). Remove
the lower left and right door hinges ( 10 ).
sett-_g up 11