Entone Hydra HD A-Series User Manual page 50

Hydra HD – A Series User's Guide
Picture shows
on the primary
TV but not any
other TV
No sound
Multi-channel
sound not
working
No sound, poor
sound or
popping noise
on HDMI
• Check that the RF cable is properly
connected between the "MATV OUT" and the
main video source socket.
• Check that the TV is set to the proper
channel (10, 23, or 39) and in CATV mode.
• Check that the audio cable is connected to
the correct input in your device.
• Is the volume of the device turned down to
the minimum level?
• If HDMI or component is used. Try disabling
AC-3.
• If HDMI is used, check the resolution and try
to use the composite audio output.
• Check with service provider that programs
contain multi-channel AC-3 signal.
• Check that AC-3 is enabled in the Hydra HD.
• Check your TV or A/V equipment for AC-3
multi-channel setup.
• HDMI is an evolving technology, so it is
possible that some TVs may not operate
properly with Hydra HD. In case of problem,
use component video output and composite
audio output to connect your primary TV.
Section 5 – Connecting
TV(s) in Another
Room(s)
Section 6 – Connecting
to Audio System
Section 6 – Connecting
to Audio System
Section 4 – Connecting
the Primary TV
Copyright © © © © 2008 Entone, Inc. All rights reserved
.