Using User Menu - Entone Hydra HD A-Series User Manual

Hydra HD – A Series User's Guide
In "TV OUT", decoder 1 by default is set to channel 10. In "MATV OUT", decoder 1, 2 and 3 by default are
set to channel 10, 23 and 39 respectively.
You can change the channel ID used by decoder 1, 2 or 3 by using the decoder 1 User Menu.
Follow procedures in section Using User Menu, to make the changes.
NOTE:
Decoder 1 channel ID in "TV OUT" and "MATV OUT" cannot be set separately. They can only be set
together.
You can only set the channel ID by using decoder 1 User Menu.
The new channel ID will only take effect after rebooting the Hydra HD.
Do not set decoders to use the same channel ID.
It is recommended to use channel IDs farther apart for the 3 decoders to minimize inter-modulation
interference. For example, do not use consecutive channel ID 10, 11 and 12 for decoder 1, 2 and 3.
Use channel ID 10, 23 and 39 instead.
You can use decoder 1 User Menu to set the HDMI and Component output resolution. You can also use
the Hydra HD front panel "UP" arrow to set the resolution. The setting made in both ways is the same.
To use User Menu to set the output resolution, follow procedures in section Using User Menu, to make the
changes.
Please refer to section Setting HDMI and Component Output Resolution for details of setting resolution.
You can use decoder 1 User Menu to control decoder 1 closed captioning. You can also use remote control
"LANG" button to control decoder 1 closed captioning. The setting made in both ways is the same.
To use User Menu to set closed captioning for decoder 1, follow procedures in section Using User Menu, to
make the changes.
Please refer to section Closed Captioning for details of controlling closed captioning.
You can use decoder 1 User Menu to control the fan speed or turn off the fan at all. 3 fan speeds; high,
middle and low are provided. You can control the fan speed with fan noise level which is acceptable to you.
To ensure good heat dissipation, it is not recommended to turn off the fan.
Follow procedures in section Using User Menu, to make the changes.
Copyright © © © © 2008 Entone, Inc. All rights reserved
.