Entone Hydra HD A-Series User Manual page 24

Hydra HD – A Series User's Guide
Follow these steps to use the in-home cabling system:
1. Connect "MATV OUT" to the main video source of your in-home cabling system using the RF cable
provided.
2. Connect the tuner input of the remote TV(s) in other rooms to an existing wall cable outlet using a RF
cable.
3. Plug in your Hydra HD and turn on the power using your remote control.
4. Plug in your TV.
5. Tune the other TV sets to channel 10 for decoder 1, channel 23 for decoder 2 and channel 39 for
decoder 3.
NOTE: In the "MATV OUT", the Hydra HD is factory set to use channel 10 for decoder 1, channel 23 for
decoder 2 and channel 39 for decoder 3.
Figure 5-2 Connecting TV(s) in Another Room(s)
In order for the Hydra HD to feed video signal to TV using "TV OUT" or "MATV OUT", your TV must be
configured to receive signal from CATV rather than from the antenna.
Most TVs use either a physical switch located on the rear of the TV or with on-screen programming to
configure to use CATV. Consult your TV owner's manual for instruction if required.
Copyright © © © © 2008 Entone, Inc. All rights reserved
.