Entone Hydra HD A-Series User Manual page 21

Hydra HD – A Series User's Guide
Figure 4-5 Connecting Primary TV using HDMI
NOTE:
All the A/V outputs are always hooked to decoder 1.
HDMI is an evolving technology, so it is possible that some TVs may not operate properly with Hydra
HD. Component output is the preferred way to connect to your HD TV.
When the HDMI connection cannot be verified by your TV, disconnect the HDMI cable and then
connect it again, or turn off the TV and then turn it on again.
Analog DVI is not supported. If your TV supports digital DVI but not HDMI, you can use an HDMI to DVI
convector cable or adaptor to connect the Hydra HD HDMI to the TV DVI. In this case, you need to
connect the audio cable separately.
Be sure to use an HDMI cable with the HDMI logo.
If your TV does not support multi-channel audio, the Hydra HD will output PCM audio only.
Please refer to the next section to set the Component and HDMI output resolution.
Copyright © © © © 2008 Entone, Inc. All rights reserved
.