Careand Cleaning Of The Range - GE JGSP22 Owner's Manual

Careand cleaning of the range.
Be sure electrical power is off and aft surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
How to Remove Packaging Tape
To assure no dmnage is done to the finish
_ffthe product, the satest way to remove
the adhesive left fl'om packaging tape on
new appliances is an application at a
household liquid dishwashing detergent,
mineral oil or cooking oil.
Apply Mth a soft clofl_ and allow to soak.
_A]pe dry and then apply an appliance
polish to thoroughly clean and protect
the sm'ti_ce.
NOTE: Theplastic tape must be removed from all
chrome tam. It cannot be removedif it is baked on.
Pull the knob straight off flTestem.
Control Knobs
Clean up spatters with a damp cloth.
Remove heavier soil with wam_, soapy
w;IteI:
Donot use abrasivesof any kind on the control
panel.
The control knobs may be removed fin.
easier cleaning. To remove a knob, pull it
straight off the stem. XA'ash the knobs in
So[Ip [llld w;IteI" gilt do not soak.
Burner car.
!
Burner nea0
Mixing tu0e _park igntter
I
Burner bawl
CAUTION:DO NOT OPERATE TIlE
BURNER WITHOUTALL BURNER
PARTSIN PLACE
22
Burner Assembly
The bm'ner assemblies should be washed
regularly and, of com_e, after spillove_.
Turnall controls off before remowbg burner parts.
The burner grates, burner heads and
btlI'neI" c}lps C}lll be rell/oved ti)r easy
cleaning. Removing them gives you
access to the bm'ner bowls.
The electrode of the spark igniter is
exposed beyond the smti_ce _ff the
burner bowl. _._]/ell cleaning the burner
bowl, be carefld not to snag the electrode
of the spark igniter with your cleaning
cloth. Damage to the igniter couM occm:
Toavoid snagging a cloth on the spark
igniter, leave the burner heads in place
when cleaning the burner bowls.
Be careful
not to push in any cooktop
controls while cleaning the burner bowls.
A slight electrical shock might result
which could Catlse vail to knock over hot
cookware.
XAhsh bm'ner parts with an all-pml)ose
non-abrasive cleaner
_llld W_li3i/wateI:
Soak stubborn soil. Dry them with a
cloth--do not reassemble while wet.
If the igniter orifice gets dirty or clogoed
you inav use a small sewing needle to
remoxe the soil.
To reassemble, replace the bm'ner head
fi_t, then the burner cap and finally the
burner grate.