Invacare Patriot Owner's Operator And Maintenance Manual page 55

5. Push the opposite end of the elastic cord up through the slotted hole in the wheel lock
extension handle.
6. Run the cord through the washer and tie a knot above the washer as shown in FIGURE
9.8.
7. Pull the cord back down into the wheel lock extension handle.
8. Install the new rubber tip.
9. Slide wheel lock extension handle over existing handle.
10. Test to ensure wheel lock works properly.
Rubber Tip (STEP 8)
Spacer (STEP 3)
Button Screw
(STEPS 2 and 4)
Wheel Lock Assembly
(STEP 2)
FIGURE 9.8 - HIGH MOUNT WHEEL LOCK EXTENSION HANDLE
Part No 1088909
SECTION 9—ANTI-TIPPERS/WHEEL LOCKS
Knot (STEP 6)
Elastic Cord
(STEPS 3 and 5)
Washer (STEPS 2 and 4)
INSTALLATION
55
Washer (STEP 6)
Wheel Lock Extension
Handle (STEP 5)
Existing Handle (STEP 9)
Locknut (STEPS 2 and 4)
Patriot™