Verifying The Repo Port Connection - HP R7000 INTL User Manual

Main menu
—
Event Log
Measurements
—
—
—
—
Control
—
—
—
—
Settings
—
—
—
—
—
—
—
—
—
—
—
Identification

Verifying the REPO port connection

NOTE:
disrupt critical operations.
After connecting the REPO port (on page 21):
Submenu
Battery status
—
Output
Output
Output
Input
Battery
Go to Bypass mode
Battery Test
Reset error state
Load segments
Restore factory settings
Change language
User Password
Set date and time
Control commands from serial
port
Output voltage
Auto start delay
Automatic on battery shutdown Selects load segment and delay time in seconds
On battery notice delay
Site wiring fault alarm
Battery low alarm
Automatic battery test
LCD contrast
—
While testing, operate connected equipment in a safe test mode so the effects do not
Display information or menu function
Battery Charging/Floating/Resting, Charge
Level, ERM Number, and Runtime
Displays events and alarms
Output watts and VA
Output amps and power factor
Output voltage and frequency
Input voltage and frequency
Battery voltage and percent charge
Transfers the UPS system to internal Bypass
mode
When this command is active, the option
changes to Go to Normal mode.
Schedules a battery test
Reset alarms
Turns load segments on or off
Resets the UPS back to factory settings
Changes language settings. The default is
English.
Enables or disables password. Default: Disable.
If Enable is selected, the password is USER. The
password cannot be changed.
Sets date and time
Enables or disables serial port control
commands. Default: Enabled
Sets output voltage
Selects load segment and delay time in seconds
Sets delay time in seconds
Enables or disables site wiring fault alarm. The
default is Disabled
Sets battery low alarm. Default: 3 minutes.
Enables or disables battery test. Default:
Disabled
Change LCD contrast. Default: +0
UPS Type / Part Number / Serial Number /
NMC Firmware / Comm Firmware / UPS
Firmware
UPS operations 33