Mounting The Gpsmap 392/398/492/498 - Garmin GPSMAP 392, 398, 492, 498 Owner's Manual

A > M GPSMAP 392/398/492/498
PPENDIX OUNTING THE
To install the GPS antenna:
1. Screw the antenna directly onto the 1
2. Route the cable to the mounting location of the unit. Use the
appropriate tie-wraps, fasteners, and sealant to secure the
cable along the route and through any bulkhead or deck.
3. After the GPSMAP 492/498 unit is installed, connect the
cable to the antenna connector on the back of the unit.
Make sure that you turn the antenna cable connector 1/4
turn clockwise to lock the cable into place.

Mounting the GPSMAP 392/398/492/498

Using the Swivel Bracket Mount
The GPSMAP 392/398/492/498's compact, waterproof case is
suitable for mounting in exposed locations or at the nav station.
The unit comes with a single-knob tilt & swivel bracket that can be
used for surface or overhead mounting.
88
When choosing a location for the display unit, make sure you
consider the following conditions:
"
x 14-thread mount.
• There should be at least a 3" (7 cm) clearance behind the
case to allow connection of the antenna (external antenna
only), power/data cables.
• The mounting surface should be heavy enough to support the
unit and protect it from excessive vibration and shock.
• For GPSMAP 392/398/492/498 unit's with the built-in
internal antenna, should be mounted in a location that
provides a clear, unobstructed view of the sky in all
directions to ensure the best reception. Avoid mounting the
unit where it is blocked by the boat's superstructure, a radar
arch, or mast.
NOTE: The temperature range for the GPSMAP
392/398/492/498 is 5°F to 158°F (-15°C to 70°C). Extended
exposure to temperatures exceeding this range (in storage or
operating conditions) can cause failure of the screen. This type
of failure and related consequences are NOT covered by the
manufacturer's limited warranty.
GPSMAP 392/398/492/498 Owner's Manual