Sfx Satellite Front Control Panel; Input; Dsp Send; Dsp Return - Fender SFX Satellite Reference And Owner's Manual

SFX SATELLITE FRONT CONTROL PANEL

A. INPUT - Plug your guitar amplifier's preamp
output or its effects send output in here.
B. DSP SEND - This knob adjusts the input level
received from your guitar amp to the SFX Satellite,
setting the level of signal input to the Digital Signal
Processing card. Rotating the knob to the right
increases the signal level input to the DSP card. Set
the knob so your average playing level lights the
yellow "signal" light. Playing peaks should not light
the red "clip" light as this will indicate distortion.
C. DSP RETURN - This knob adjusts the output
level from the DSP card and the wet dry signal mix
prior to the SFX matrix. Rotating the knob to the
right increases the signal level input to the SFX
Satellite amplifier.
D. SFX ON / OFF - This push-push button is the On
/ Off control of the Stereo Field eXpansion or SFX
effect. When the button is out, the SFX signal will
not emanate from the bottom speaker, however,the
SFX front signal is still sent to your traditional amp.
Turning off the SFX feature does not impact the DSP
effects sent to your amplifier. Note: Refer to the
chart on page 7 for the various configurations
available when using the SFX On/Off and Bypass
buttons and Footswitch.
E. SFX - This knob controls the volume level of the
bottom speaker.
increases the volume to the bottom speaker varying
the SFX spatial effect.
F. SFX ON - This green LED illuminates when the
SFX effect is active on your SFX Satellite.
G. OUTPUT LEVEL - Controls the signal level from
the SFX Satellite to your guitar amp's power amp
input or effects receive input.
H. OUTPUT - This 1/4 inch jack sends the signal
from your SFX Satellite to your guitar amp's power
amp input or its effects receive input.
6
Rotating the knob clockwise