Table of Contents
Advertisement
SFX SATELLITE FRONT CONTROL PANEL
I. BYPASS - This push-push button is the On / Off
switch for the bypass feature. When this button is
pressed, the SFX and DSP effects are bypassed and
the guitar amp's signal is routed back to your
amplifier.
Note: Refer to the chart below for the
various configurations available when using the SFX
On/Off and Bypass buttons and Footswitch.
J. F/S BYPASS - This jack, for the one button
footswitch (included), is used for hands free
deactivation of the SFX effect.
overrides the bypass switch. When the footswitch is
pressed the SFX and DSP effects are inactive and the
guitar's signal is routed directly back to your amplifier.
Switch Control Table
Bypass
SFX On/Off
Button In
Button In
Button In
Button Out
Button Out
Button Out
Button Out
Button In
Using this jack
Result
Guitar Amp Only
-No Effects
Guitar Amp Only
-No Effects
Guitar Amp w/ DSP Effects
-No Satellite Sound
SFX Effect Active
-Sound from Satellite
K. DSP EFFECTS - This 32-position data wheel
selects among the various on-board digital effects.
These effects will only be heard if the DSP Send and
Receive knobs are turned up. For a complete listing
of all on-board effects available refer to the chart
located on page 8.
L. SIGNAL - This yellow LED illuminates when an
adequate signal level exists at the DSP input. CLIP -
This red LED illuminates when an excessive signal
level exists at the DSP input. If this occurs lower the
input signal via the DSP Send knob.
M. POWER INDICATOR - This LED illuminates when
your SFX Satellite is receiving power.
N. POWER SWITCH - Turns the AC power ON and
OFF. When the switch is OFF, the SFX Satellite is
completely shut down.
7
Advertisement
Table of Contents
