To Select Generated Waveform Types And Settings; 18, "Save/Recall (Setups, Screens, Data - Agilent Technologies InfiniiVision 3000 X-Series User Manual

A waveform generator is built into the oscilloscope. It is enabled by
Option WGN or the DSOX3WAVEGEN upgrade. The waveform generator
gives you an easy way to provide input signals when testing circuitry with
the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope
setups. See
page 275.

To select generated waveform types and settings

1 To access the Waveform Generator Menu and enable or disable the
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
17
Waveform Generator
To select generated waveform types and settings
To edit arbitrary waveforms
To output the waveform generator sync pulse
To specify the expected output load
To use waveform generator logic presets
To add noise to the waveform generator output
To add modulation to the waveform generator output
To restore waveform generator defaults
Chapter 18, "Save/Recall (Setups, Screens, Data)," starting on
waveform generator output on the front panel Gen Out BNC, press the
[Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is
illuminated. When waveform generator output is disabled, the [Wave
Gen] key is off.
263
s1
259
267
267
268
269
269
274
259