Garmin GPS GPS 60 Owner's Manual page 53

To change the Serial Data Format:
1. From the Setup Menu, highlight 'Interface' and press
2. Highlight the 'Serial Format' field and press
3. If you select Text Out and/or RTCM In, additional fields will appear.
Use the ROCKER key to highlight 'Baud Rate' and press
the key to highlight the desired setting and press
ROCKER
4. For Garmin DGPS or RTCM In/NMEA Out, use the
highlight 'Beacon' and press
'Scan' or 'User' and press
If you select 'Scan,' the GPS 60 will automatically direct the beacon
receiver to scan for available beacon transmitters.
If you select 'User,' select the 'Freq' and 'Bit Rate' fields and enter
the appropriate settings. The beacon status, signal-to-noise ratio and
distance to beacon are displayed in the bottom of the page.
ENTER
.
ENTER
ROCKER
. Use the key to select
ENTER ROCKER
ENTER .
.
ENTER . Use
.
ENTER
key to
GPS Navigation
The Setup Menu
43