Table of Contents
Advertisement
APPENDIX A INSTALLATION DETAILS FOR BEECH V35B
1 . 0
INTRODUCTION
This appendix provides airframe specific information which is necessary to install the
GARMIN GPS 150 navigation system in the Beech Bonanza Model V35B in accordance
with STC SA00066WI.
150 system is approved for use as a supplementary navigation system under Visual
Flight Rules (VFR) only.
A-1.
The information provided herein is to be considered supplemental to the information
contained in the GARMIN GPS 150 Aviation Kit Installation Manual, P/N 190-00026-
00.
Within this appendix, the base document will be referred to as the "Installation
M a n u a l " .
2 . 0
INSTALLATION INSTRUCTIONS
2 . 1
ANTENNA
The GPS 150 antenna is to be installed on top of the cabin on the aircraft centerline
at fuselage station 130.
to section 2.1 of the Installation Manual for general antenna mounting requirements.
2 . 2
AVIATION RACK INSTALLATION
The GPS 150 aviation rack is to be installed in the instrument panel radio rack as
shown in figure A-3.
to the pilot when seated at the controls.
To install the aviation rack, position it in the instrument panel in the desired position,
assuring that the front is not twisted out of square.
rack to the installation holes on the GPS 150 aviation rack.
and self locking nuts, attach the aviation rack to the aircraft panel.
information, refer to the Installation Manual.
2 . 3
WIRING
Fabricate an appropriate cable to connect the GPS 150 aviation rack to 28VDC power,
a message annunciator, a remote switch (for selecting between GPS and standard
navigation equipment), a transfer switch with integral white, illuminated annunciators
with black markings (to control and indicate the status of the remote switch).
connections are to be made in accordance with Figure A-4.
be as shown in Figure A-3.
Circular AC-43.13-2A.
operation of all flight controls throughout their range to assure that no operational
interference exists.
Av. Kit Install. Manual
190-00026-00 Rev. Q
Page 22
See Appendix C for copy of STC.
A functional block diagram of the system is shown in Figure
Figure A-2 illustrates the proper antenna positioning.
The controls and display of the GPS 150 must be readily visible
Route and connect the wiring in accordance with Advisory
After the wiring installation is complete, carefully check the
When so installed, the GPS
Match drill the flanges on the radio
Using 4 each #6-32 screws
Breaker locations are to
Refer
For additional
Wiring
Advertisement
Table of Contents
