Table of Contents
Advertisement
with sealant.
Insure that the mounting screws are fully tightened and that the
antenna base is well seated against the gasket.
grade RTV sealant or sealants containing acetic acid.
the electrical connections to the antenna.
antenna
warranty.
3 . 3
CABLE INSTALLATION
A. Route the coax cable to the rack location keeping in mind the recommendations
of Section 2.
Secure the cable in accordance with good aviation practice.
B. Trim the coaxial cable to the desired length and install the BNC connector (330-
00087-00) per the cabling instructions on Figure 3-3.
by the installer, follow the connector manufacturer's instructions for cable
p r e p a r a t i o n .
C . Contacts for the 37-pin connector must be crimped into the individual wires of the
aircraft wiring harness.
Non- GARMIN part numbers shown are not maintained by GARMIN and consequently
are subject to change without notice.
See Appendix B for information regarding obsolete stamped type contacts.
Av. Kit Install. Manual
190-00026-00 Rev. Q
Page 10
Use of these type sealants may void the
The following table lists recommended crimp tools:
CAUTION:
Do not use construction
These sealants may damage
If the connector is provided
Advertisement
Table of Contents
