Cleaning The Ui Screen; Cleaning The Second Transport And Fusing Areas - Xerox Docucolor 5000 User Manual

7. M a i nt en a nc e

Cleaning the UI screen

Cleaning the Second Transport and Fusing areas

7- 2
Clean the UI screen at the start of each day. Remove all dust and
fingerprints by wiping the screen with a clean, lint-free cloth.
CAUTION: To avoid damage, do not use any Xerox cleaner,
water, or commercial cleaner on the screen.
Use the following procedure if your output prints have dirt or
contamination on them, or if you receive multiple paper jams in
Area 4.
NOTE: It is recommended that you perform this procedure one
time per day, preferably at the start of the day before the digital
press is switched on and the fuser is hot.
WARNING: If the digital press is switched on and the fuser is hot,
be sure to switch off the digital press power and allow 15 minutes
for the fuser to cool before performing this procedure.
1.
Open the front doors.
2.
Grasp handle 4 and move it in the direction of the arrow.
Front Doors
D o c uC ol o r 50 00 Us e r G ui d e