Dell XPS M1710 Service Manual page 20

Hide thumbs Also See for XPS M1710:
Table of Contents

Advertisement

 
2. Align the display assembly over the screw holes in the base of the computer.
NOTE:
The left hinge assembly has a small tab that you must first insert underneath the edge of the palm rest.
1
tab
NOTE:
When you replace the four screws, ensure that you tighten them in the order indicated by the labels "1," "2," "3," and "4" on the display hinges.
 
3. Replace the four M2.5 x 5-mm screws.
 
4. Connect the display cable to the system board.
 
5. Reroute the display cable into the cable channel.
 
6. Connect the LED cable to the system board.
 
7. Reroute the LED cable in the cable channel.
 
8. Replace the hinge cover (see
 
9. If a Mini-Card is installed, connect the antenna cables to the card (see Mini-Card). If one is not installed, tuck the antenna cables into their secured
location.
 
Replacing the Hinge
Cover).

Advertisement

Table of Contents
loading

Table of Contents