Using The Program Memos; Adding Patterns Created Using The Bas-Pc/300 - Brother LH4-B800E Instruction Manual

5-5. Using the program memos

5-6. Adding patterns created using the BAS-PC/300

You can use the BAS-PC/300 to create your own sewing patterns. Up to nine of the patterns which you
create in this way can be programmed into a P-ROM.
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the
wall outlet before opening the face plate of the control box. Touching areas where high voltages are
present can result in severe injury.
(1)
2132Q
Adding patterns to a P-ROM
1. Remove the six screws (1), and then open the operator's side cover (2) of the control box.
NOTE:
When opening the cover (2), hold it securely so that it does not fall down.
2. Remove the P-ROM (3) from the main P.C. board.
3. Create the pattern(s) using the BAS-PC/300. Refer to the Operating Instructions for the BAS-PC/300 for
details on how to create patterns.
4. Add the pattern(s) created using the BAS-PC/300 to the P-ROM (3).
5. Install the P-ROM (3) to the main P.C. board so that it faces as shown in the illustration.
6. Close the cover (2) of the control box, and tighten the six screws (1).
(2)
(1)
2131Q
DANGER
(2)
HE-8000
Insert the program memos (1) into the rear of the
operation box (2) for safekeeping.
Program memo contents
1. Easy reference guide
2. Error code table
3. Parameter table
4. Program notes
Use a lead pencil to make any additions to the
parameter table and for writing anything into the
program notes. If you do so, additions can be
removed using an eraser and the space can be re-
used. The program notes are useful for recording
what patterns have been entered into which
programs.
(3)
5. OPERATION
2133Q
53