Home Position Return (Preparation) - Brother LH4-B800E Instruction Manual

5. OPERATION

5-2. Home position return (preparation)

NOTE:
When transporting and installing the sewing machine, the thread trimming mechanism may move so that
the machine pulley cannot be turned. In such cases, do not force the pulley to turn. Move the thread
trimming mechanism to the home position, or turn the machine pulley in the reverse direction to set the
needle to the needle up stop position.
(6)
C
30
(18)
(19)
0118Q
2100Q
(1)
(14)
(14)
2101Q
2102Q
Before starting home position return......
Check that the needle bar is at its highest position.
Turn the machine pulley so that the index mark (18)
on the pulley is between the marks (19) on the belt
cover.
If the machine is started while the index mark (18) is
not between these two marks (19), error message
"E-02" will be displayed. At this time, the error will be
cleared if you turn the machine pulley to set the
needle to the needle up stop position.
1. Turn on the power.
• The POWER indicator (1) will illuminate and the
model number will appear for one second in the
parameter display LED (14).
• After this, "--" will appear in the program
number LED (6) and "----" will appear in the
parameter display LED (14).
2. Depress the treadle to the 2nd step [C].
• The sewing machine will move to the home
position, and the work clamp will move to the
neutral position.
• After the home position has been reached, the
mode will change to the mode which was active
when the power was turned off (automatic/test
feed/manual/program).
HE-8000