System Setup; Time Format - Garmin 128 Owner's Manual

REFERENCE

System Setup,

Date/Time &

Time Format

The GPS 126/128's two
operating modes are
accessed through the sys-
tem setup submenu.
To display the correct
local time, you must enter
the appropriate offset
from the chart at the end
of Appendix C.
46
System Setup
The system setup page is used to select the operat-
ing mode, time offset, and screen preferences. The GPS
126/128 has two operating modes:
Normal Mode operates the unit using satellite
•
tracking information.
Simulator Mode allows you to operate the unit
•
without acquiring satellites, and is ideal for prac-
ticing or entering waypoints and routes while at
home.
To select an operating mode:
1. Highlight the 'mode' field, and press
2. Select a mode, and press
Date and Time Setup
The date and time is located directly below the
mode field.
Note: Date and time information is derived from the
GPS satellites and cannot be changed by the user.
Because the time shown is UTC time (Greenwich
mean time), you will need to enter a time offset to dis-
play the correct local time for your area. To determine
the time offset for your area, note your position and
refer to the chart in Appendix D.
To enter the time offset:
1. Highlight the 'offset' field, and press
2. Enter the time offset, and press
Note: Move the cursor to the left to change the plus
or minus sign.
Time Format
The time display shown on the system setup and
Position Pages may be set to display the time in a 12- or
24-hour format.
To select the time format:
1. Highlight the 'hours' field, and press
2. Select 12- or 24-hour display, and press
F
.
F
.
F
.
F
.
F
.
F
.