Pace RNG150N User Manual page 5

SAFETY INFORMATION (cont.)
Safety aspects of connections
Full details of the rear panel are on page 6.
Connecting
Do not connect your set-top (or any other equipment such as a TV or VCR)
to the power supply until you have properly connected all the other cables.
Your set-top is designed for use only with the supplied power supply unit.
On the power supply unit there is a label that specifies the correct AC
power supply input for it. Do not connect the power supply unit to any
supply other than this.
Always connect the 12 volt DC cord from the power supply unit to your
set-top before you insert the AC power cord from the power supply unit
into the wall outlet.
AC
Disconnecting
To disconnect power from your set-top, always detach the power supply
unit from the wall AC outlet (rather than remove the 12 volt cord from your
set-top).
Therefore you must install your set-top near to the wall AC outlet, which
should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, consult a qualified electrician.
The CABLE IN connector is designed
for connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this
input.
To ensure correct operation, use this set-top only with the Pace-approved
power supply unit provided. If you use an unapproved alternative, you will
invalidate the warranty.
POWER INPUT
The model number, serial
number, and electrical
rating of this set-top are
on a label on its base.
12 volt power
supply unit
RNG150N / RNG200N USER GUIDE (501-3339201) B949/B950
Regulatory information
CAUTION: Do not attempt to modify your set-top without written
authorization from the manufacturer. Unauthorized modification
could void your authority to operate your set-top.
Your set-top has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. Your set-top generates, uses
and can radiate radio-frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If your set-top does cause harmful interference to
radio or television reception, which can be determined by turning your
set-top off and on, you are encouraged to try to correct the interference
by one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between your set-top and the receiver.
• Connect your set-top to an outlet on a circuit different from that to
which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
NOTE
5