Jenn-Air w10519943b Use & Care Manual page 12

Table of Contents

Advertisement

Available languages

Available languages

5. Align the alignment pin on the side of the filter with the cutout
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Install the Water Filter
1. Locate the accessory packet in the ice maker and remove the
water filter.
2. Take the water filter out of its packaging and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
B
D
C
3.
A. Cover
C. Alignment pin
B. O-rings
D. Alignment
arrow
The water filter compartment
is located in the right-hand side
of the ice maker control panel. Push in on the door to release
the latch, and then lower the door.
m
4.
A. Door
A
Attach the filter wrench to the water filter.
6.
notch in the control housing and insert the filter into the
housing.
A
C
A. Alignment pin
C. Locked symbol
B. Unlocked symbol
D. Cutout notch in control housing
Turn the filter clockwise until it locks into the housing. Ensure
that the alignment arrow on the filter head aligns with the
locked symbol on the control box housing.
NOTE: If the filter is not correctly locked into the housing, the
ice maker will not produce ice.
A
A. Alignment arrow aligned with locked symbol
7. Remove the filter wrench.
8. Push the control box door closed until the latch snaps closed.
The Water Filter Status Light
The water filter status lights will help you know when to change
your water filter.
The "Order Filter" status light will be illuminated when it is
time to order a replacement
filter.
The "Replace Filter" status light will be illuminated when it is
time to replace the filter.
Replacing the disposable water filter with a new filter will
automatically
reset the filter status tracking feature. See
"Using the Controls."
NOTES:
"Replace Filter" will remain illuminated if a filter is not
installed.
The "Filter" status light will flash if the filter is not correctly
installed or there is an obstruction
in the water line.
Replace the Water Filter
To purchase a replacement water filter, see "Accessories."
Replace the disposable water filter when indicated on the water
filter status display or at least every 9 months. If the ice making
rate decreases before the Replace Filter light illuminates, then
replace the filter.
1. Locate the water filter compartment
in the right-hand side of
the control housing. See Step 3 in the "Install Water Filter"
section.
2. Turn the water filter counterclockwise
(to the left), and pull it
straight out of the compartment.
NOTE: There may be some water in the filter. Some spilling
may occur.
3. Install the replacement water filter by following steps
2 through 6 in the "Install the Water Filter" section.
12

Advertisement

Table of Contents
loading

Table of Contents