Entering And Exiting Training Mode - Royal TS4240 User Manual

Entering and Exiting Training Mode

After a training passcode is programmed, you can use Training mode. You
can exit Training mode by turning the cash register off, moving the Reg
key to a position other than Reg, or by entering the exit code.
Note
You cannot enter or exit Training mode if Tables are open or active. For more
information about closing or using tables, see Using Tables on page 65.
To start Training mode
1 Put the REG key in the Mode key slot and turn it to the Reg position.
2 If the clerk numbers are set, press the four digit passcode and then press
3 Using the Number keys, enter 000987. Press the subtotal key.
4 Using the Number keys, enter the 6 digit passcode. Press the Amount
5 Now you can ring up sales in training mode. These sales do not appear in
To stop Training mode
1 During Training mode, end any sale in progress.
2 Do one of the following:
3 Now you can ring up sales normally. These sales appear on sales reports.
TS4240 User's Guide
the Clerk key.
Tender key. The word Training appears on the screen.
the sales reports.
• Move the Reg key to another position.
• Turn the cash register off.
• Using the Number keys, enter 000789. Press the subtotal key.
Using Training Mode
70