Furuno FS-1562-15 Operator's Manual page 16

Custom channels
Up to 200 custom channels can be programmed in addition to 412 ITU channels. You can recall
them through the keyboard by channel numbers. Once a channel is selected with the keyboard,
the channel can be changed with the FREQ/CH rotary selector.
NOTE: Custom channel programming should be done by a FURUNO service agent.
To call the channel 120, for example:
TX only
Press [TX], [RCL], [1], [2], [0], [ENT]
RX only
Press [RX], [RCL], [1], [2], [0], [ENT]
TX and RX paired
Press [RCL], [1], [2], [0], [ENT]
NOTE: The standard sets provide readout of frequencies in kHz. Pressing the [ENT] key or
operating the FREQ/CH selector shows up the CH NO. temporarily.
ITU telephony channels (SSB)
To recall ITU SSB channel 412, for example, select J3E with the [MODE] key.
Press [RCL], [4], [1], [2], [ENT], and a combination of TX frequency of 4098 kHz and RX
frequency of 4390 kHz is selected. To select only RX or TX frequency, hit [RX] or [TX] to start
with.
RX freq TX freq
DUP
R
0 2 4 6 8 10 S
Frequency indication type. Frequencies are
normally displayed. CH NO. is also displayed
temporarily by operating the FREQ/CH
selector or by pressing the [ENT] key.
AGC NB
J3E
DUP
R
0 2 4 6 8 10 S
Channel NO. indication type
Identify the frequencies by referring to the
APPENDIX. Entering 412 reads 4012 as
above. Frequencies can be read temporarily by
operating the FREQ/CH selector or by
pressing the [ENT] key.
-1.8-
BAND ITU CHANNEL NO.
AGC NB
J3E