Intercom; Remote Station - Furuno FS-1562-15 Operator's Manual

2.2 Intercom

The intercom provides communications between the FS-1562 and the RB-500 Remote Station
(option). They must be wire-connected. When intercom mode is in use, there is no radio
transmission.
Calling RB-500
1. Press the [0] INTERCOM key. "COM" appears on the FS-1562 display panel.
2. Press [1]*, [ENT] keys. Calling beeps on the FS-1562 sound. The buzzer stops when the
handset of the RB-500 is picked up. * Designated number of the RB-500 if more than one is
installed.
3. Press the PTT switch to talk. Release the switch to listen.
Call from RB-500
When the FS-1562 is called from the RB-500, the FS-1562 releases a beep. Press the [ENT] key
to silence the buzzer. Press the PTT switch to talk. Release the switch to listen.
Terminating the intercom
Press the [0] INTERCOM key to terminate intercom function. "COM" disappears.

2.3 Remote Station

Priority:
The Remote Station usually has higher priority than the FS-1562. This means that operation of the
FS-1562 is disabled when the handset of the RB-500 is picked up. The label "REM" appears on
the FS-1562 display when the remote control unit is in operation.
Communication on 2182 kHz
When 2182 kHz is selected on the FS-1562, the FS-1562 takes priority.
However the Remote Station can control FS-1562 when you give priority to the Remote Station
by system setting on the FS-1562 (ROM ver. 107 and after of FS-1562).
-2.2-