Sony DVW-A500/1 Service Manual page 132

Menu List
Item number Item
307
AUTO-DELETION
FOR
INCONSISTENT
DATA
308 SELECTION OF
(with optional STD/NON-STD
BKDW-505 for FOR COMPOSITE
DVW-500/1 VIDEO IN
series, and
BKDW-506 for
DVW-500P/1
series)
309
SERVO/AV
REFERENCE SEL
A-16
Appendix
Settable range Function
Specifies the action taken when an edit point is incorrectly
[0] [manual]
set.
neg & excess
1
0 : a warning message is output on the display on the lower
neg
2
1 : When an incorrect edit point is set, (i.e., an OUT point
2 : When an incorrect edit point is set (i.e., an OUT point
Note
Editing is not performed on the VTR while a warning
message aprears in the display.
[0] [auto]
Select the STD or NON-STD signal mode according to the
forced STD
1
composite video input signal.
forced non-STD
2 0 : Detect automatically whether the input luminance signal
1 : The unit is in the STD mode at all times.
2 : The unit is in the NON-STD mode at all times. Use this
The servo reference is selected by the following settings.
[0]
[auto 1]
1 0: During recording, the analog component/composite or
auto 2
2
external
1: When the [F2] (OUT REF) button in the PF1 menu is set
2: SYS1 ROM version 1.06 and higher
control panel. Delete manually the unnecessary edit
points or correct the erroneous edit point manually.
located before an IN point, or AUDIO OUT point before
AUDIO IN point) the previously set edit point is deleted
automatically.
When excessive edit points are set, the previously set
edit point is deleted automatically.
located before an IN point, or AUDIO OUT point located
before AUDIO IN point) the previously set edit point is
deleted automatically.
When excessive edit points are set, a warning message
appears in the display on the lower control panel.
and chrominance signal are interleaved or not. If
interleaved, the STD mode is selected. If not
interleaved, the NON-STD mode is selected.
mode when color framing of the video input signal is not
stable.
digital video input signal is selected as the servo
reference signal.
During playback, the signal selected by the [F2] (OUT
REF) button in the PF1 menu (factory setting) on the
lower control panel is selected as the servo reference
signal. When the signal selected by the [F2] (OUT REF)
button in the PF1 menu (factory setting) on the lower
control panel is not connected, the internal reference
signal is selected.
to "ref", and the unit is in edit preset mode, the reference
signal for video/audio signal processing is locked to the
video input signal.
The servo reference is forced into the EXT mode.