Table of Contents
Advertisement
4.3.4 Time synchronization
In the top right corner of the screen you have another button that leads to a new
screen where you can synchronize the clock of your PND to the very accurate time
provided by the connected GPS.
Turn on the Auto Correction switch to let The NVX235W Navigator frequently check
and correct the PND time with the GPS time.
Below that button you will see the current values of the GPS and the PND clocks.
You can check here whether any correction is needed. Tap the
button to
manually synchronize the time.
Below the PND time you have
and
controls to manually correct the time with
or without a valid GPS time. It also gives you the chance to correct the time after
synchronization if your PND does not support time zones or daylight saving time.
You can also use these buttons if you prefer to set the PND time from this screen
instead of using the time setup features of the operating system.
4.4 The map
The most important and most frequently used screens of The NVX235W Navigator
are the two screens with the map (Map screen and Cockpit screen). They are similar
in look and in possible controls but are optimized for different uses. The map they
display is common. The elements of the map are described here. For the controls
and special functions of the two map screens see 4.5.
The current version of The NVX235W Navigator is primarily intended for land
navigation. That is why maps in The NVX235W Navigator look similar to paper
roadmaps (when using daytime colors and 2D map mode). However, The NVX235W
Navigator provides much more than regular paper maps can. The look and the
contents can be changed.
4.4.1 2D and 3D map views
Besides the classical top down view of the map (called 2D mode), you have the
possibility to tilt the map to have a perspective view (3D mode) that gives a view
similar to that seen through the windscreen with the possibility to see far ahead.
20
Advertisement
Table of Contents
