Table of Contents
Advertisement
If the value limits are not displayed at the ends of the slider, the leftmost position
means the minimum value, while the rightmost position represents the maximum
value.
This control can be operated in two ways. Either drag the handle to move the slider
to its new position, or tap the slider where you want the handle to appear (the thumb
jumps there immediately). As with the list selectors, there is no need to confirm your
selection. As soon as you leave the screen, the selected value becomes effective.
3.2.4 Switches
When a function can only have two values (mainly Enabled and Disabled), a switch is
used. Unlike with list selectors, the horizontal line contains the name of the function
and not the actual status. There is a lamp on the left to show whether the function is
active or not.
When the lamp is dark (
), the function is not selected. When it is lit (
), the
function is enabled. The whole strip works as a button. Tap anywhere to toggle
between the enabled and disabled status.
3.2.5 Special switches
Some switches behave differently. Instead of being dark when not selected, the light
turns red and the lamp becomes crossed out (
) to emphasize the prohibition of
use. Furthermore the switches used for the road types (to be included or avoided
when planning a route) in the Route Parameters screen (5.4.4) cannot be changed
for some vehicle types. When such a vehicle is selected, not only the lamp but also
the whole line becomes inactive and dark.
Use these buttons the same way as you would other switches. Tap them anywhere
to toggle between the enabled and disabled states.
3.2.6 Switches in the Quick menu
The switches of the Quick menu (4.7.2) behave as normal switches but they look
different in order to fit in with the other menu buttons.
14
Advertisement
Table of Contents
