Furuno ETR-30N Operator's Manual page 32

2.3.2 ETR-30N and ETR-6/10N
When installing an ETR-30N and an ETR-6/10N, the ETR-6/10N's host name of SOUNDER
cannot be changed. For this reason, the set the HOST NAME control of the ETR-30N to "1"
and its host name to "SOUNDER1." Turn the ETR-30N off and on again after setting the
HOST NAME control to register settings.
1. Set tappings of ETR-30N as in paragraph 2.2.1.
2. Set the HOST NAME control of the ETR-30N to "1" and turn on the power.
3. As shown in paragraph 2.2.2, set sounder source for "SOUNDER1" on the NavNet
display unit as below.
a) Rotate the [ENTER] knob to choose SOUNDER SOURCE.
b) Press the EDIT soft key.
c) Enter SOUNDER1 with the numeric keys.
d) Press the RETURN soft key.
Note: The HOST NAME control setting and sounder source name (numeric) must agree.
(See the table below.) If not, the equipment cannot function.
4. Set the ETR-30N as shown in paragraph 2.2.3.
HOST NAME
control setting
on ETR-30N
1
Note: The host name and frequency on the ETR-6/10N are fixed to SOUNDER and 50/200
kHz, respectively.
Change sounder
source to "SOUNDER1."
NavNet
Display Unit 1
Set up
transducer.
If the ETR-6/10N is generating interference, use the interference rejector on the NavNet
display unit to reject it. If that does not work, contact your dealer for advice.
SOUNDER SOURCE set
on NavNet display unit
SOUNDER1
ETR-30N
HOST NAME: 1
Installation with ETR-30N and ETR-6/10N
Turn power
off to set.
NavNet
Display Unit 2
HUB
ETR-6/10N
14
NavNet
Display Unit 3