Furuno ETR-30N Operator's Manual page 28

3. TRANSDUCER SETUP is selected; press the EDIT soft key.
4. Use the [ENTER] knob to choose MODEL NUMBER and then push the [ENTER] knob.
5. Use the [ENTER] knob to choose HIGH FREQUENCY and then push the [ENTER]
knob.
6. Rotate the [ENTER] knob to choose transducer and then push the [ENTER] knob.
7. Confirm tap position at the SNDR SETUP screen.
8. If a low-frequency transducer is installed, set it following this procedure.
9. Turn off the NavNet display unit.
10. Turn on the NavNet display unit. Confirm that the echo sounder picture advances.
TRANSDUCER SETUP
HIGH FREQUENCY
LOW FREQUENCY
TAP SETTINGS MUST BE MADE ON
ETR UNIT.
AFTER SETUP, DISPLAY MUST BE
TURNED OFF & ON TO ALLOW
NEW SETTINGS TO TAKE EFFECT.
Frequency setup screen
TRANSDUCER SETUP
MODEL NUMBER
MANUAL
Transducer type setting method options
HIGH FREQUENCY
28kHz 28F-8
28kHz 28F-18
28kHz 28F-24H
38kHz 38E-9-18S1
45kHz 45F-12H
50kHz 50B-6/6B
50kHz 50B-9/9B
50kHz 50F-8G
50kHz 50/200-1ST
50kHz 50/200-1T
Frequency options
10
SNDR
MANUAL
SETUP
--kHz
EDIT
(0kW TAP:-)
--kHz
(0kW TAP:-)
RETURN