Calling A Station - Furuno DP-6 Operator's Manual

5.2 Calling a Station

1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
Station Name
Frequency (T/R) :
Comm Status
Sending Volume
1. Press function key [F3] to display the Operate menu.
1: Call Station
2: Macro Operation
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: High Tension ON
9: Manual Calling
0: Set Frequency
Figure 5-4 Operate menu
2. Press the [1] key to display the Station List.
3. Select the station you wish to call.
4. Press the [Enter] key to establish connection with the station.
: CHOUSHI-8M
8765.00 / 8965.00(kHz)
: Connect Send
: 100(%) ARQ Error : 0
Figure 5-5 Communication status display
"Connect" appears in inverse video on the Comm Status line when
an acknowledge signal from the station called is detected. (In the
ARQ mode connection may be delayed due to signal condition. In
the FEC mode, however, "Connect" appears in inverse video a few
seconds later since the acknowledge signal is not required.)
Operate
1996-11-15 14:28 (JST)
Comm Mode :ARQ
Lock Error
ARQ Time : 0(sec)
Caps
5-3