Table of Contents
Advertisement
3. With the help of a second person, carefully tip the
Uprights (64) back to the vertical position.
3
Attach the Latch Assembly (32) to the left Upright (64)
with two Extension Screws (35).
Note: There may already be two pieces of Foam Tape
(82) attached to each post. If there are not, peel the paper
off two of the included pieces of Foam Tape. Press the
Foam Tape onto the left post in the locations shown.
Press the other two pieces of Foam Tape onto the right
post in the same way.
35
32
82
4. Turn one of the Handrail Extensions (34) so that the two
larger holes are on the bottom as shown, Insert the
Handrail Extension as far as possible into the post on the
left Upright (64). If necessary, tap the Handrail Extension
with a rubber mallet to fully insert it. Next, attach the
Handrail Extension by tightening three Extension Screws
(35) into the indicated holes.
Identify the Left Foam Grip (31) (see the inset drawing).
Remove any remaining paper from the two indicated
pieces of Foam Tape (82). Apply a small amount of water
to the Foam Tape. Slide the Left Foam Grip as far as pos-
sible onto the post on the left Upright (64). (Note: It may
be helpful to lubricate
the Handrail
Extension
[34]
with soapy water.) Press two Plastic Fasteners (9) into
the Foam Grip and the Handrail Extension (34). If neces-
sary, use a blunt object to press in the Fasteners.
Attach the other Handrail Extension (not shown) and the
Right Foam Grip (43) as described above. Note: Make
sure that the Extension Screws (35) are attached on the
outside of the post as shown.
4
31
82
5. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 24). To protect the
floor or carpet from damage, place a mat under the treadmill,
7
Hide quick links:
Advertisement
Table of Contents
