Toro TimeCutter Z4235 74365 Operator's Manual page 28

Every 100 hours--Change the engine
oil. (more often in dusb. dirty
conditions)
Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run five minutes. This
warms the oil so it drains better.
,
,
Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completel>
Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
,
Stop the engine, remove the ke), and wait for all
moving parts to stop before leaving the operating
position (Figure 29).
=L->','_2_ a
G012157
J
S
J
Figure 29
G01215_
Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil
to bring it to the Full mark (Figure 30).
1
3
2
4
4
6
G008796
Figure 30
Changing the Engine Oil Filter
Service Interval: Every 200 hours--Change the oil
filter• (more often in dust?, dirty
conditions)
Note: Change the engine oil filter more frequently
when operating conditions are extremely dust T or sand?_
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Change the engine oil filter (Figure 31).
28