Chec_Ng The Engine Oil Level; Starting And Stopping The Engine - Toro TimeCutter Z4235 74365 Operator's Manual

1. Fuel gauge window
Figure 9
Checking the Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Chec_ng
the Oil Level in the Engine Maintenance section.
Starting and Stopping the
Engine
Starting the Engine
1. Sit down on the seat and move the motion controls
ouhvard to the park position.
2. Disengage the blades by moving the blade control
switch to Off (Figure 11)
Filling the Fuel Tank
1. Shut the engine off and set the motion controls to
the park position. Raise the seat so the gas tank is
visible while fueling.
2. Clean around the fuel tank cap and remove the cap.
,
Add unleaded regular gasoline until the body of the
tank is full but fuel does not fill the neck of the
tank (Figure 10). This space in the neck of the tank
allows gasoline to expand. Do not fill the fuel tank
completely full.
4. Install the fuel tank cap securel> Wipe up any
gasoline that may have spilled.
Figure 11
1. Control panel 2.
G005182
Blade control switch--Off
position
G005302
Figure 10
1. Gas tank body 3. Fill to here, approximately
2. Gas tank neck 4. Gas tank opening
,
Pull up on the Choke control before starting a cold
engine (Figure 12).
Note: A warm or hot engine may not require
cho_ng.
16