Advertisement
OPERATING THE ELECTRONIC MONITOR
1. To turn on the power, press the on/dear button or
simply begin exercising on the AIR WALKER. The
entire display will appear for two seconds. The
electronic monitor will then be ready for operation.
2. Select one of the five modes:
Scan all mode--When
the power is tumed on, the
scan all mode will be selected automatically. The
scan all mode can also be selected by repeatedly
pressingthe mode button. One mode indicator will
show that the scan all mode has been selected,
and a second mode Indicator will show which
mode is currently displayed.
Repshttln, reps, calories, or time mode--These
modes can be individually selected by repeatedly
pressing the mode button. The mode indicators
will show which mode has been selected. (Make
sure that the scan all mode is not selected.) The
modes will be selected in the following order:.
reps/min, reps, calories, scan all, time.
.
The monitor has an auto-off feature to turn off
the power, If the pedals are not moved and the
monitor buttons are not pressed for four minutes,
the power will tum off automatically in order to
conserve the batteries.
To reset the LCD display, press-the on/dear button.
MAINTENANCE AND TROUBLE-SHOOTING
MAINTENANCE
Inspect and tighten all pods of the AIR WALKER reg-
ularly. Replace any wom parts immediately.
The AIR WALKER can be deaned with a soft, damp
doth. Keep liquids away from the electronic monitor.
Keep the monitor out of direct sunlight or the display
may be damaged. Remove the batteries when storing
the AIR WALKER:
ELECTRONIC MONITOR TROUBLE-SHOOTING
If the electronic
monitor will not turn
on, the batteries
should be checked.
Using a coin, pry up
the front of the
monitor and remove
R from the console
(see figure 1).
Fig. 1
Console
See figure 2. If there
is a gap between
the positive (+) ends
of the battedss and
the metal contacts,
the monitor will not
turn on. Push the
batteries to make
•sure that the posi-
tive ends are
touching the metal
contacts.
Fig. 2 _ ,Metal Contact
_"
>Batteries
I
Back of Monitor
See figure 3. Make
sure that the reed
switch wireisplugged
intothe monitor;, i need
any excess wire into
the console. Srap the
monitorinto the con-
sole. Make sure that
the wire is not pinched
between the monitor
and the console.
Fig. 3
MonitorI
Reed Switch Wire
If the electronic monitor still does not function proper-
ly, the batteries should be replaced. Two "AA" batter-
ies are required; alkaline batteries are recommended.
Remove the two old batteries from the monitor, and
insed two new bettedss. Make sure that the nega-
tive (-) ends of the batteries
are touching the
springs, and that the positive
(+) ends of the bat-
teries are pushed egalnst the metal contacts.
3
Advertisement
