Advertisement
ASSEMBLY
Before you begin assembly, carefully read the
following Information and InstrucUons:
• Place all pads of the AIR WALKER in a cleared
area and remove the packing materials.
IMPORTANT: DO NOT REMOVE THE RUBBER
BANDS FROM THE HUB COVERS (see
assembly step 5). Do not dispose of any
packing matedals until assembly is completed.
• Use the drawings below to identify the small
hardware used in assembly.
• Read through each assembly step before you
begin.
• Make sure that all parts are odented as shown in
the drawings. "lighten all pads as you assemble
them, unless Instructed to do otherwise.
Assembly requires the following tools:
/
• the Included allen wrench
_
-=:J
• your own phillips screwdriver
(__
3/8" Curved Washer (27)-4
@©
3/8" x 1/2" Screw (24)-8
#8 x 1/2" Screw (31)-8
1,
,
Before you begin, read the Information at the
top of this page.
See figure 1. Rnd the Left Upright (3). Note:
There is a "TOP LEFT" sticker on the upper
end of the Left UpdghL
See figure 1. Slide the Left Updght (3) onto the
Base (1). Thread two 3/8" x 1/2" Screws (24) into
the Left Upright. Do not tighten the Screws yet.
See figure 1. Attach the Right Updght (4) in the
same manner.
See figure 2. Hold the Top Frame (2) level, and
insert it into the Left and Right Updghts (3 and 4).
Note: It may be helpful to rock the Top Frame
from side to side slightly as you insert IL
Make sure that the indicated rubber bands are
not pinched between the Top Frame and the
Uprights. Attach the Top Frame with four 3/8" x
1/2" Screws (24).
See figures 1 and 2. "Rghtenthe eight 3/'8" x 1/2"
Screws (24).
Fig. 1
Fig, 2
Sticker
RIGHT"
Sticker
24
Rubber
Band
2
Rubber
Band
24
24
4
Advertisement
