Danby DAC6020 Use And Care Manual page 7

1. Preparation to Remove the
Air Cond[tloner Slide-Out Chassis
• Position the air conditionerIn the normal (upright)
position,,
• Remove the air fitter by grasping the filler handte
(on front grill) and sliding it to the right.
• Remove the phillips screw (behind filter) securing
the grill frontto the chass[s_(Fig.,2)
• Remove the phiilips screws located on the (lower
left/right) edge of front grill, (Fig,l)
To remove the frontgrill, grasp the lower front
corner of 'thegrill, pulling (gently) oulward and
upward. (Fig3)
Repeat this step on the 3 remaining corners,
• Remove the two IJhtllIps screws (lower left/rlght
side of cabine't)seeudng the slide-out-chassis
to the cabtneL (Fig,5)
NOTE:These screws must be reinstalled
upon completion of the window installation.
(to secure slide-out-chassis) •
. Grasp the pull handle at the front of the
slide-out-chassis and carefully slide the air
conditioner out of the cabinet. (Fig.4)
Please seek assistance for this procedure,
Fig, 1
GRItJL FRONT 8 CRE'W
Fig. 2 Fig. 3
Fig,4
Fig. S